module mips_cpu_harvard_tb( input logic clk, input logic reset ); parameter INSTR_INIT_FILE = "inputs/lw/lw-1.instr.txt"; parameter DATA_INIT_FILE = "inputs/lw/lw-1.data.txt"; parameter TIMEOUT_CYCLES = 100; logic clk_enable, active, data_read, data_write; logic[31:0] register_v0, instr_address, instr_readdata, data_readdata, data_writedata, data_address; mips_cpu_harvard_memory #(INSTR_INIT_FILE, DATA_INIT_FILE) ramInst( .clk(clk), .data_address(data_address), .data_write(data_write), .data_read(data_read), .data_writedata(data_writedata), .data_readdata(data_readdata), .instr_address(instr_address), .instr_readdata(instr_readdata) ); mips_cpu_harvard cpuInst( .clk(clk), .reset(reset), .active(active), .register_v0(register_v0), .clk_enable(clk_enable), .instr_address(instr_address), .instr_readdata(instr_readdata), .data_address(data_address), .data_write(data_write), .data_read(data_read), .data_writedata(data_writedata), .data_readdata(data_readdata) ); // Generate clock /* initial begin $dumpfile("mips_cpu_harvard.vcd"); $dumpvars(0,mips_cpu_harvard_tb); clk=0; repeat (TIMEOUT_CYCLES) begin #10; clk = !clk; #10; clk = !clk; end $fatal(2, "Simulation did not finish within %d cycles.", TIMEOUT_CYCLES); end initial begin reset <= 1; @(posedge clk); reset <= 0; @(posedge clk); assert(active==1); else $display("TB: CPU did not set active=1 after reset."); while (active) begin @(posedge clk); end @(posedge clk); $display("TB: CPU Halt; active=0"); $display("Output:"); $display("%d",register_v0); $finish; end */ endmodule